Ip Ssh Authentication-Retries - Dell S4810 Reference Manual

ip ssh authentication-retries

Configure the maximum number of attempts that should be used to authenticate a user.
S4810
Syntax
ip ssh authentication-retries 1-10
Parameters
1-10
Defaults 3
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage This command specifies the maximum number of attempts to authenticate a user
Information on an SSH connection with the remote host for password authentication. SSH
disconnects when the number of password failures exceeds authentication-retries.
ip ssh connection-rate-limit
Configure the maximum number of incoming SSH connections per minute.
S4810
Syntax
ip ssh connection-rate-limit 1-10
Parameters
1-10
1504
Enter the number of maximum retries to authenticate a user.
The range is from 1 to 10. The default is 3.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the number of maximum numbers of incoming SSH
connections allowed per minute. The range is from 1 to 10
per minute. The default is 10 per minute.
Security