Dot1X Auth-Server - Dell Z9500 Reference Manual

Parameters
vlan-id
max-attempts
number
Defaults 3 attempts
Command CONFIGURATION (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.4.1.0
Usage
If the host responds to 802.1X with an incorrect login/password, the login fails. The
Information
switch attempts to authenticate again until the maximum attempts configured is
reached. If the authentication fails after all allowed attempts, the interface moves
to the authentication failed VLAN.
After the authentication VLAN is assigned, the port-state must be toggled to restart
authentication. Authentication occurs at the next reauthentication interval (dot1x
reauthentication).
Related
•
Commands
•
•

dot1x auth-server

Configure the authentication server to RADIUS.
Z9500
Syntax
dot1x auth-server radius
184
Enter the VLAN Identifier. The range is from 1 to 4094.
(OPTIONAL) Enter the keywords max-attempts followed
number of attempts desired before authentication fails. The
range is from 1 to 5. The default is 3.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
dot1x port-control
dot1x guest-vlan
show dot1x interface
802.1X