Renault Laguna III Manual page 2568

Condenser: Removal - Refitting
F4R or K4M or K9K or M4R or M9R, and AIR CONDITIONING 01 or AIR CONDITIONING 02
a Unclip the condenser.
a Remove the condenser in the direction of the arrows
(5) and (6) .
AIR CONDITIONING
122873
122875
62A-12
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the seals on the condenser connect-
ing pipes.
WARNING
Do not remove the blanking plugs from each
component until the last moment.
Also, do not remove the components from their
packaging until they are to be fitted to the vehi-
cle.
II - REFITTING OPERATION FOR PART
CONCERNED
a
WARNING
To avoid any leaks, check that the pipe surface is
sound before positioning the new seal. The sur-
face must be clean and scratch free.
a Lubricate the seals using recommended air condi-
tioning oil (see 62A, Air conditioning, Air condi-
tioning: Parts and consumables for the repair,
page 62A-2) to make fitting easier.
a Fit new seals on the condenser connecting pipes.
a Refit the condenser.
a Clip:
- the condenser,
- the left-hand air deflector,
- the air pipe onto the left-hand deflector.
a Remove the blanking plugs.
a Connect the connecting pipes to the condenser.
a Torque tighten the connecting pipe nuts (8 N.m).
a Clip on the right-hand air deflector.
III - FINAL OPERATION.
a Refit:
- the front end panel (see Front end panel: Remov-
al - Refitting) (42A, Upper front structure),
- the headlights (see Headlight: Removal - Refit-
ting) (80B, Headlights).
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
62A