Renault Laguna III Manual page 2580

Compressor: Removal - Refitting
V4Y or V9X, and AIR CONDITIONING 01 or AIR CONDITIONING 02
Equipment required
refrigerant charging station
Tightening torquesm
compressor bolts
compressor bolts
compressor bolts
« compressor -
condenser » connect-
ing pipe bracket bolt on
the compressor
« intermediate pipe -
compressor » connect-
ing pipe bracket bolt on
the compressor
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 62A, Air conditioning, Air condition-
ing: Precautions for the repair, page 62A-1) .
Note:
Use blanking plugs for the fuel circuits with part
numbers 77 01 208 229 or 77 01 476 857 to plug
any openings exposed to the open air. The y must
be clean. Do not use any which have already been
used to plug a fuel circuit.
WARNING
To prevent moisture from entering the system,
place plugs on the cold loop components which are
open to the air.
AIR CONDITIONING
25 N.m
55 N.m
61 N.m
8 N.m
8 N.m
62A-24
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
WARNING
Consult the device's operating manual to avoid
incorrect use.
a Drain the refrigerant circuit using the refrigerant
charging station (see 62A, Air conditioning, Re-
frigerant circuit: Draining - Filling, page 62A-7) .
a Remove:
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
- the accessories belt (see Accessories belt: Re-
moval) (11A, Top and front of engine).
V4Y
a Remove:
- the bolt (1) from the « compressor - condenser »
connecting pipe bracket on the compressor,
62A
134987