HP ProCurve 7102dl Reference Manual page 1059

SROS Command Line Interface Reference Guide
ip rip receive version [1 | 2]
Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets
received on the interface.
Syntax Description
1
2
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Functional Notes
Use the ip rip receive version to specify a RIP version that overrides the version (in the Router RIP)
configuration.
The SROS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the loopback interface to accept only RIP version 2 packets:
ProCurve(config)#interface loopback 1
ProCurve(config-loop 1)#ip rip receive version 2
5991-2114
Accepts only received RIP version 1 packets on the interface.
Accepts only received RIP version 2 packets on the interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Loopback Interface Configuration Command Set
1057