B Command Line Interface Usage; Logging On To An Mpx200 - HP StorageWorks MPX200 User Manual
Hp storageworks mpx200 multifunction router user guide (5697-0568, august 2010)
Hide thumbs
Also See for StorageWorks MPX200:
- User manual (258 pages) ,
- Solution manual (224 pages) ,
- Quickspecs (17 pages)
Table of Contents
Advertisement
B Command Line Interface usage
The CLI enables you to perform a variety of MPX200 management tasks through an Ethernet or serial
port connection.
Logging on to an MPX200
You can use either Telnet or Secure Shell (SSH) to log on to a router, or you can log on to the switch
through the serial port.
To log on to a router using Telnet:
1.
On the workstation, open a command line window.
2.
Enter the Telnet command followed by the router IP address:
# telnet <ip address>
A Telnet window opens and prompts you to log in.
3.
Enter an account name and password.
To log on to a router using SSH:
NOTE:
SSH works in a way similar to Telnet, except it uses ROSA to encode transmissions to and from your
workstation and the MPX200 blade.
1.
On the workstation, open a command line window.
2.
Enter the ssh command followed by the router IP address:
# ssh <ip address>
An SSH window opens and prompts you to log in.
3.
Enter an account name and password.
To log on to a switch through the serial port:
1.
Configure the workstation port with the following settings:
• 115,200 baud
• 8-bit character
• 1 stop bit
• No parity
2.
When prompted, enter an account name and password.
MPX200 Multifunction Router User Guide
211
Advertisement
Table of Contents
Troubleshooting
