Calculate:obwidth:marker[1]|2|3|4:Trace <Integer; Calculate:obwidth:marker[1]|2|3|4:Trace:auto Off|On|0|1; Calculate:obwidth:marker[1]|2|3|4:Trace:auto - Agilent Technologies N1996A-503 User Reference

are no markers turned on. If a marker is currently active, press
4
is underlined. The active marker will be moved to the selected trace.
Mode
Remote Command
Example
Dependencies /
Couplings
Preset
State Saved
Range
Key Path
Auto Init
Turns automatic initiate On or Off. When
is automatically determined by the analyzer whenever the marker turns on (Normal or
Delta) from an Off state. Auto Init is set to On at
flowchart depicts the Auto Init rules:
Chapter 3
SA
:CALCulate:OBWidth:MARKer[1]|2|3|4:TRACe <integer>
:CALCulate:OBWidth:MARKer[1]|2|3|4:TRACe?

:CALCulate:OBWidth:MARKer[1]|2|3|4:TRACe:AUTO OFF|ON|0|1

:CALCulate:OBWidth:MARKer[1]|2|3|4:TRACe:AUTO?

CALC:OBW:MARK2:TRAC 4
CALC:OBW:MARK2:TRAC:AUTO OFF
This key is only available on measurements that have multiple traces.
Trace selection is preset to Auto, so the default trace depends on the
available traces and the predefined order of selection.
Saved in State
The number of traces available to put a marker on, varies depending on
the current selected measurement. In the OBW measurement, 4 traces
are available.
Marker, Marker Trace
Auto Init
is set to On the marker's trace attribute
Preset
Occupied Bandwidth Measurement
Marker Trace
until
All Markers Off
or . The following
Mode
1 2 3
, , , or
101