Command
REF nrf
REF?
Command
*RST
MEMORY CLEAR
Command
CLM nrf
3-10
Table 3-3. Reference Selection
Response
REF nr1
RESET
The *RST command returns all tuner parameters to their reset values (the
same values which occur at power up). The reset command does not affect
the contents of channel memory or SRQ registers. The commands in this
message category are listed in Table 3-4.
Table 3-4. Reset
Response
The memory clear (CLM) command allows clearing of channel storage
memory. If the CLM 1 command is sent, storage memory will be cleared.
The command in this message category is listed in Table 3-5.
Table 3-5. Memory Clear
Response
Description
Set Reference to Internal or External
0 = Internal Reference
1= VXI Bus Reference
2 = External Reference
Request Reference Setting
Reset: REF 0
Example: REF 1
Description
Set all tuner device messages to the reset values.
Description
Clear channel storage memory.
nrf
Description
1
Clear channel storage memory
E2730A VXI RF TUNER
OPERATION