Ip Bgp Neighbor Passive - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

BGP Commands

ip bgp neighbor passive

Configures the local BGP speaker to wait for this peer to establish a connection. When enabled, the local
BGP speaker will not initiate a peer session with this peer; in this sense, the BGP speaker is "passive."
When disabled, the local BGP speaker will attempt to set up a session with this peer.
ip bgp neighbor ip_address passive
no ip bgp neighbor ip_address passive
Syntax Definitions
ip_address
Defaults
This command is disabled by default.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to disable passive peer behavior.
•
By default BGP will initiate a session to a peer once the peer is configured, has an AS number, and is
enabled. You can use this command to configure the local BGP speaker as passive and an outbound
session will not be initiated to this peer. For such peers, BGP will always wait passively for the
inbound session attempt.
•
The BGP peer is restarted after issuing this command.
Examples
-> ip bgp neighbor 172.22.2.115 passive
-> no ip bgp neighbor 172.22.2.115 passive
Release History
Release 7.1.1; command was introduced.
Related Commands
ip bgp neighbor
MIB Objects
alaBgpPeerTable
alaBgpPeerAddr
alaBgpPeerPassive
OmniSwitch CLI Reference Guide
32-bit IP address of the BGP peer.
Creates or deletes a BGP peer.
March 2011
ip bgp neighbor passive
page 19-77