BGP Commands
ip bgp policy prefix-list
Creates or deletes a prefix match list.
ip bgp policy prefix-list name ip_address ip_mask
no ip bgp policy prefix-list name ip_address ip_mask
Syntax Definitions
name
ip_address
ip_mask
Defaults
No IP BGP policy prefix-list exists.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command creates prefix lists that can be applied to a peer's inbound and outbound routes using
the
ip bgp neighbor in-prefixlist
routes based on one or more prefixes, as shown in the example below. If the route matches the prefix
list filter, according to the ge (lower) and le (upper) limits defined, then the permit or deny action
associated with the prefix applies.
•
General or more specific prefix list information can be displayed by varying the use of the
command.
Examples
-> ip bgp policy prefix-list prefixListA 12.0.0.0 255.0.0.0
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
Prefix list name.
IP address for the prefix list.
Mask for the prefix list.
and
ip bgp neighbor out-prefixlist
March 2011
ip bgp policy prefix-list
commands. The prefix list filters
show ip bgp
page 19-111