Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 46

2
Setting Up
3
4
46
Find out if automatic configuration via DHCP or AutoIP can be used.
Also, find out whether your network supports Dynamic DNS or
Multicast DNS.
If automatic configuration is not supported, get the oscilloscope's
network parameters (hostname, domain, IP address, subnet mask,
gateway IP, DNS IP, etc.).
Connect the oscilloscope to the local area network (LAN) by inserting
LAN cable into the "LAN" port on the back of the oscilloscope.
Configure the oscilloscope's LAN interface:
Press the Configure softkey until "LAN" is selected.
a
Press the LAN Settings softkey.
b
Press the Config softkey, and enable all the configuration options
c
supported by your network.
If automatic configuration is not supported, press the Addresses
d
softkey.
Use the Modify softkey (and the other softkeys and the Entry knob)
to enter the IP Address, Subnet Mask, Gateway IP, and DNS IP
values.
When you are done, press the [Back up] key.
Press the Host name softkey. Use the softkeys and the Entry knob to
e
enter the Host name.
When you are done, press the [Back up] key.
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide