Update Ethernet Encapsulation Type; Set: Set Ethernet Type - 3Com CoreBuilder 9000 User Manual

Update Ethernet
Encapsulation Type
Update the Ethernet encapsulation type of the CoreBuilder 9000 ATM
Enterprise Switch. The options are:


1-ETH: Standard encapsulation — according to 802.3


0-LLC: Enhanced encapsulation
The default Ethernet encapsulation type is 1-ETH.
For more information, see "Ethernet Encapsulation Type" on page 418.
The Ethernet ecapsulation type is updated after the next reboot.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Ethernet encapsulation
type
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 2 7 2 1
The following message is displayed:
Eth Type was successfully set for the next reboot.
The Ethernet encapsulation type is updated to ETH and takes effect after
the next reboot.
Setting Up for Management
(1) SET: Switch Setup
(2) MNG: Management Setup
(7) ETH: Ethernet Type Setup

(2) SET: Set Ethernet Type

Format or Range
1 for type ETH
0 for type LLC
1 1 2 7 2 [parameters]
The Ethernet encapsulation type is updated.
Eth Type was successfully set for the
next reboot.
79