Update Ip Address; Sip: Set Ip Address - 3Com CoreBuilder 9000 User Manual

Update IP Address

Update the IP address of the CoreBuilder 9000 ATM Enterprise Switch.
The default factory IP address is
The IP address is changed after the next reboot.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Enter a parameter at the prompt
Parameter
IP Address
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 2 1 2 100.0.2.2
The following message is displayed:
IP address was successfully set for next reboot.
The IP address is updated to 100.0.2.2 and takes effect after the next
reboot.
CAUTION: Make sure to change the factory default IP address to a valid
IP address that matches your network IP addresses.
Setting Up for Management
0.0.0.0.
(1) SET: Switch setup
(2) MNG: Management setup
(1) SIP: IP Setup

(2) SIP: Set IP Address

Format or Range
Valid IP address
1 1 2 1 2 [parameters]
The IP address is updated.
IP address was successfully set for
next reboot.
67