Update Network Prefix - 3Com CoreBuilder 9000 User Manual

150 C 6: M
HAPTER ANAGING
Update Network
Prefix
N I
ETWORK NTERFACES
Update the Network Prefix in the CoreBuilder 9000 ATM Enterprise
Switch.
The prefix update takes place after the next reboot.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Network Prefix
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 6 2
The following prompt is displayed:
Enter parameter(s): 'Net Prefix(13 bytes - First byte: 47, 39
or 45)'
Enter a network prefix.
The switch network prefix was set for the next reboot.
(1) SET: Switch Setup
(6) SNP: Switch Network Prefix Setup
(2) SET: Set Network Prefix
Format or Range
13 bytes - First byte: 47, 39 or 45
1 1 6 2 [parameters]
The network prefix is updated for the next reboot.
The switch network prefix was set for
the next reboot.