Update Signaling
Protocol Version
Update the signaling protocol version of the ports of the
CoreBuilder 9000 ATM Enterprise Switch and save it to flash.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Enter a parameter at the prompt
Parameter
Port number
Protocol version
Confirmation
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 5 4
3.1.2
The following prompt is displayed:
This operation will release all connections of the specified
port(s)!
Are you sure (Y/N)? Y
Enter
to confirm,
Y
N
The following message is displayed:
Signaling Protocol Version was successfully set.
The signaling protocol version for port 3.1.2 is updated to 3.1 and saved.
(1) SET: Switch setup
(4) SIG: Signaling setup
(5) SPS: Signaling protocol
(4) SPV: Set protocol version
Format or Range
<slot.group.port>; Enter 0.0 for all ports
0 for version 3.0
1 for version 3.1
Y or N
1 1 4 5 4 [parameters]
The signaling protocol version is updated for the
specified port.
Signaling Protocol Version was
successfully set.
1
to cancel.
Signaling Setup
configuration setup
193