Update Signaling Protocol Profile - 3Com CoreBuilder 9000 User Manual

190 C 7: C
HAPTER ONFIGURING
Update Signaling
Protocol Profile
V C
IRTUAL HANNELS
Update the signaling protocol profile for the selected port. See the
previous section for details. This command causes the new Signaling
Protocol Parameters to be activated in the current session, and the new
value is stored in flash. If a new value is not entered and stored in flash,
the ATM Enterprise Switch reverts to the previous value of the Signaling
Protocol Parameters the next time that it reboots.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Enter a parameter at the prompt
Parameter
Port number
Signaling profile
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 5 2 3.1.2
The following message is displayed:
This operation will release all connections of the specified
port(s)!
Are you sure (Y/N)?
Enter to confirm,
Y N
The following message is displayed:
The profile was set successfully.
The signaling protocol for port 3.1.2 is updated to Network and saved.
(1) SET: Switch setup
(4) SIG: Signaling setup
(5) SPS: Signaling protocol
configuration setup
(2) SPR: Set profile of port
Format or Range
<slot.group.port>; Enter 0.0 for all ports
0 for user profile
1 for network profile
1 1 4 5 2 [parameters]
The signaling protocol profile is updated. for the
specified port.
Parameter was successfully set
1
to cancel.