Add Atm Address To Port; Add: Add Atm Address - 3Com CoreBuilder 9000 User Manual

Add ATM Address to
Port
Add an ATM address to the list of registered ATM addresses at a port.
Enter the port number and ATM address. Use this command, for
example, with devices that do not support ILMI; you must add ATM
addresses manually to interface with such devices.
Command Actions
Enter the menu sequence: (3) CON: Connections
Enter a parameter at the prompt
Parameter
Port ID
ATM address
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
3 4 2 2 5.1.2 47.0.0.0.0.0.3c.0.0.b*
The following message is displayed.
ATM address was successfully set.
ATM Addresses Port Table
(4) S&C: Setup and Config Connections
(2) STP: Static ATM Addresses Setup

(2) ADD: Add ATM Address

Format or Range
<slot.group.port>
19 bytes - When fewer: end with '.*'
3 4 2 2 [parameters]
Specified ATM address is added to specified port.
ATM address was successfully set.
141