Table of Contents
Advertisement
4.2 Addition of Base and Station Axis
MAX. RPM
ACCELARATION SPEED:
INERTIA RATIO
<Phenomenon1> During motion, the axis moves unsteady on advance direction.
$$$$$$$) Confirm the motion with increasing this ratio in each 100.
<Phenomenon2> during pause, the motor makes a lot of noise.
$$$$$$$) Confirm the motion with decreasing this ratio in each 100.
*3
After this motor specification setting, the display moves to the next axis. Set them for all
axes.
When [ENTER] is pressed at the motor specification display for last axis, the setting in
this display is completed and the confirmation dialog is shown.
If "YES" is selected, the system parameter is modified automatically.
The addition of the base axis setting is complete.
AC Servo Motor
:
Input maximum rotation speed of a motor. (Unit: mm)
Input time between 0.01 and 1.00 to reach maximum
speed from stopping status at 100% JOINT motion.
(Unit: sec)
:
"300" when in case of traveling axis or " 0" when in case
of rotation axis is set as initial value.
But if the following phenomenon occurs in motion,
deal with the followed procedure.
M O T O R S P E C
B1
:RECT-XYZ
A X I S T Y P E : B A L L - S C R E W
MOTOR
S G M P - 1 5 A W Y R 1
Modify?
AMP
CONVERTER
JUSP-ACP35JAB
ROTATION DIRECTION
Y E S
MAX RPM
ACCELARATION TIME
INERTIA RATIO
!Maintenance Mode
4-12
Normal direction
AXIS:3
JUSP-WSA3AB
N O
FORWARD
2000 rpm
0.300 sec
300
Advertisement
Chapters
Table of Contents
