9 Replacing Parts
9.1
Replacing XRC Parts
• Turn OFF the power supply before opening the XRC doors.
Failure to observe this warning may result in electric shock.
• After turning OFF the power supply, wait at least 5 minutes before
replacing a servopack or power supply unit. Do not touch any terminals
during this period.
Failure to observe this warning may result in electric shock.
• To prevent anyone inadvertently turning ON the power supply during
maintenance, put up a warning sign such as "DO NOT TURN ON THE
POWER" at the primary power supply (knife switch, wiring circuit
breaker, etc.) and at the YASNAC XRC and related controllers and use
accepted lockout/tagout procedures.
Failure to observe this caution may result in electric shock or injury.
• Do not touch the regeneration resistors. They are very hot.
Failure to observe this caution may result in burn injuries.
• After maintenance is completed, carefully check that no tools are left
inside the YASNAC XRC and that the doors are securely closed.
Failure to observe this caution may result in electric shock or injury.
W A R N I N G
C A U T I O N
9-1
9.1 Replacing XRC Parts