Closing A Traverse - Leica TS03 User Manual

7.14.5
Access
Close Traverse...
Next step
140
Field
Next step
Close the traverse by selecting Close in the Sight Foresight screen after a
backsight point measurement, but before the foresight point measurement.

Closing a Traverse

Close the traverse by selecting Close in the Sight Foresight screen after a
backsight point measurement, but before the foresight point measurement.
Field
F1 ...at Known Station to
Known Closing Point
F2 ...to Known Closing
Point
F3 ...at Known Station
Only
F4 ...Leave Open
Select an option, from the Close Traverse... menu to proceed to the Traverse
Results screen.
Description
1. Enter the name of the check point and
the height of the reflector.
2. Press Cont to go to the next screen.
3. Measure the check point. The differences
in Easting, Northing and Height are dis-
played.
A message will appear if the tolerances
defined in the Traverse configuration are
exceeded.
Description
To close a traverse at a known station to a
known closing point.
Use when setup on the closing station, and
the coordinates for the station and the clos-
ing point are known.
☞
If this method is chosen a distance
measurement is mandatory.
1. Input the data for both points.
2. Measure to the closing point.
3. The results are displayed.
To close a traverse to a known closing point.
Use when setup on an unknown station and
only the coordinates of the closing point are
known.
1. Input the data for the point.
2. Measure to the closing point.
3. The results are displayed.
To close a traverse at a known station only.
Use when setup on the closing station and
the coordinates for it are known.
1. Input the data for the closing station.
2. The results are displayed.
To leave the traverse open. There is no last
traverse station.
1. The results are displayed.
Apps