Dlp-H69 Create An Ip-Encapsulated Tunnel - Cisco ONS 15310-MA SDH Procedure Manual

In the Circuit Source area, complete the following:
Step 5
•
•
•
Click Next.
Step 6
In the Circuit Destination area, complete the following:
Step 7
•
•
•
Click Finish.
Step 8
Return to your originating procedure (NTP).
Step 9

DLP-H69 Create an IP-Encapsulated Tunnel

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Each ONS 15310-MA SDH can have one IP-encapsulated tunnel. Terminated Section DCCs used by the
Note
ONS 15310-MA SDH cannot be used as tunnel endpoints, and a Section DCC that is used as a tunnel
endpoint cannot be terminated. A tunnel connection is bidirectional.
Step 1 Verify that IP addresses are provisioned at both the source and destination nodes of the planned tunnel.
For more information, see the
Step 2 In network view, click the Provisioning > Overhead Circuits tabs.
Step 3 Click Create.
In the Overhead Circuit Creation dialog box, complete the following in the Circuit Attributes area:
Step 4
•
•
•
Click Next.
Step 5
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-86
Node—Choose the source node.
Slot—Choose the source slot.
Port—If displayed, choose the source port.
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If displayed, choose the destination port.
This task creates an IP-encapsulated tunnel to transport traffic from
third-party SDH equipment across ONS networks. IP-encapsulated tunnels
are created on the Section DCC channel (D1-D3) (if not used by the
ONS node as a terminated DCC).
STM-M cards must be installed.
NTP-H36 Verify Network Turn-Up, page 5-4
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Name—Type the tunnel name.
Type—Choose IP Tunnel-D1-D3.
Maximum Bandwidth—Type the percentage of total RS-DCC bandwidth used in the IP tunnel (the
minimum percentage is 10 percent).
"DLP-H39 Provision IP Settings" task on page
Chapter 16 DLPs H1 to H99
16-52.
78-19416-01