Versions - Omron NY532-1500 Reference Manual

Versions

Hardware revisions and unit versions are used to manage the hardware and software in NY-series Con-
trollers and EtherCAT slaves. The hardware revision or unit version is updated each time there is a
change in hardware or software specifications. Even when two Units or EtherCAT slaves have the same
model number, they will have functional or performance differences if they have different hardware revi-
sions or unit versions.
Checking Versions
You can check versions on the ID information indications or with the Sysmac Studio.
Checking Unit Versions on ID Information Indications
The unit version is given on the ID information indication on the back side of the product.
The ID information on an NY-series NY5 2-1
Checking Unit Versions with the Sysmac Studio
You can use the Sysmac Studio to check unit versions. The procedure is different for Units and for Eth-
erCAT slaves.
Checking the Unit Version of an NY-series Controller
You can use the Production Information while the Sysmac Studio is online to check the unit version
of a Unit. You can only do this for the Controller.
• Right-click CPU Rack under Configurations and Setup − CPU/Expansion Racks in the Multiv-
iew Explorer and select Production Information.
The Production Information Dialog Box is displayed.
Changing Information Displayed in Production Information Dialog Box
Click the Show Detail or Show Outline Button at the lower right of the Production Information Dia-
log Box.
The view will change between the production information details and outline.
NY-series Motion Control Instructions Reference Manual (W561)
ID information indication
Unit version
Ver.1.
Controller is shown below.
Versions
21