Station Number - NEC Univerge sv8500 Manual

[2] Station Number

Assigning LOC-ID on a Station Number (STN) basis meets the requirement for more flexible configura-
tion. By putting a specific station in an individual location, the station can be used in different bandwidth
from other stations. The figure below shows a network configuration where LOC-IDs are assigned on a
Station Number basis.
Note 1: This figure is a simple image. As a matter of fact in this configuration, other LOC-IDs called "Dummy
Location" should be assigned. Dummy Location is set on a branch point where multiple network routes
branch off. It combines these routes into one and helps you to use Bandwidth Control more flexibly.
For more information about Dummy Location, refer to the Data Programming Manual - Business.
Network Address:
10.40.182.0/25
Network Address: 10.40.160.0/24
Location ID=4
Location whose Location ID is assigned on a network address basis
Location whose Location ID is assigned on a Station Number basis
Segment
CHAPTER 2
Note 1
Peer to Peer Bandwidth Control (by Location ID)
Location ID=1
IP Network
Location ID=0
VOL.1-119
IP-RELATED BASIC FEATURE PROGRAMMING
Location ID=2 Location ID=3
Network Address: 10.40.182.128/25