NEC Univerge sv8500 Manual page 187

1st - 15th LOC-ID: Enter LOC-ID which relays START LOC-ID and END LOC-ID.
When START LOC and END LOC are adjacent to each other, leave the routing table blank.
(d) The routing table is set by pressing "Set."
(e) By pressing "Disp", Bandwidth border data on a location-location basis can be displayed in Band-
width border data field (on the right of the window).
Data: Display the existence information of bandwidth border data on a location-location basis.
O/X (Bandwidth border data is existing/not existing)
<Bandwidth border data> Field
(f) Assign the bandwidth border values.
LOC-ID: Indicates locations whose bandwidth border values are displayed below.
<Normal bandwidth data> -This value is applied for 24 hours -
Assign the following data related to Normal Bandwidth
Limit value (Kbps):
Warning value (Kbps): Assign warning value of Normal bandwidth. (1-16777215) At this value, sys-
Alarm:
<Particular bandwidth data> - This value is applied only for specified time zone. A maximum of 10
Assign the following data related to Particular Bandwidth
Time zone:
Note: Do not assign duplicate time zone.
Note: Do not assign time zone across 00:00. (Ex. 23:00~01:00 is not allowed.)
Limit value (Kbps):
Warning value (Kbps): Assign warning value of Particular bandwidth. (1-16777215) At this value, sys-
Alarm:
(g) By pressing the Set button, the values are set.
(h) By pressing the Disp button between locations whose bandwidth border data has not been assigned,
assign the bandwidth border data one by one. If the bandwidth border data is not required, this proce-
dure is not necessary.
CHAPTER 2
Assign maximum value of Normal bandwidth. (1-16777215)
tem message "36-G/36-H" is issued as a warning.
System message "36-I/36-J" output 0/1 = Provided/not provided
time zone patterns can be assigned -
Time zone to which the specified bandwidth value is applied Assign the value
00:00~23:59 format.
Assign maximum value of Particular bandwidth. (1-16777215)
tem message "36-G/36-H" is issued as a warning.
System message "36-I/36-J" output 0/1 = Provided/not provided
VOL.1-127
IP-RELATED BASIC FEATURE PROGRAMMING