Pci Bus Parking - Motorola MPC8240 User Manual

PCI Bus Arbitration
devices are programmed to the same priority level, or if there is only one device in the low
priority group, then the arbitration algorithm defaults to each device receiving an equal
number of bus grants, in round-robin sequence.
Figure 7-2 shows an example of the arbitration algorithm. Assume that several masters are
requesting use of the bus. If there are two masters in the high priority group and three in the
low priority group, then each high-priority master is guaranteed at least 1 out of 3
transaction slots, and each low-priority master is guaranteed 1 out of 9 transaction slots.
In Figure 7-2, the grant sequence (with all devices except device 4 requesting the bus and
device 3 being the current master) is 0, 2, MPC8240, 0, 2, 1, 0, 2, 3, ... and repeating. If
device 2 is not requesting the bus, then the grant sequence is 0, MPC8240, 0, 1, 0, 3, ... and
repeating. If device 2 requests the bus when device 0 is conducting a transaction and the
MPC8240 has the next grant, then the MPC8240 will have its grant removed and device 2
will be awarded the grant since device 2 is of higher priority than the MPC8240 when
device 0 has the bus.
High Priority Group Low Priority Group
Device 2 Device 1
(1/3) (1/9)
Low
priority
Device 0 Device 3
MPC8240
slot
(1/3) (1/9)
(1/9)
(1/3)
Figure 7-2. PCI Arbitration Example

7.2.3 PCI Bus Parking

When no device is using or requesting the bus, the PCI arbiter grants the bus to a selected
device. This is known as parking the bus on the selected device. The selected device is
required to drive the AD[31:0], C/BE[0:3] and PAR signals to a stable value, preventing
these signals from floating.
The parking mode control parameter (bits 14–13) in the PACR determines which device the
arbiter selects for parking the PCI bus as shown in Table 7-1. If the parking mode control
bits are 0b00 (or if the bus is not idle), then the bus is parked on the last master to use the
bus. If the bus is idle, and the parking mode control bits are b10, then the bus is parked on
the MPC8240; if the control bits are b01, then the bus is parked on device 0 (that is, the
device connected to GNT0).
Chapter 7. PCI Bus Interface 7-7