Permit (For Standard Ip Acls) - Dell MXL 10GbE Reference Manual

Usage
The Dell operating system supports one ingress and one egress IP ACL per
Information
interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your line card documentation.
Example
Dell(conf)#ip access-list standard TestList
Dell(config-std-nacl)#
Related
ip access-list extended
Commands
resequence access-list

permit (for Standard IP ACLs)

To permit packets from a specific source IP address to leave the switch, configure a filter.
Syntax
permit {source [mask]| any | host ip-address} [count [byte]]
[dscp value] [order] [fragments] [log [interval minutes]
[threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
•
•
Parameters
source
mask
any
host ip-address
count
bytes
dscp
150
— creates an extended access list.
— Displays the current configuration.
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no permit {source [mask] | any | host ip-address}
command.
Enter the IP address in dotted decimal format of the network
from which the packet was sent.
(OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address or hostname.
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword bytes to count bytes
processed by the filter.
(OPTIONAL) Enter the keyword dcsp to match to the IP
DCSCP values.
Access Control Lists (ACL)