Match Ip Precedence - Dell Z9500 Reference Manual

match ip precedence

Use IP precedence values as a match criteria.
Z9500
Syntax
match {ip | ipv6 | ip-any} precedence ip-precedence-list [set-
ip-dscp value]
To remove IP precedence as a match criteria, use the no match {ip | ipv6 |
ip-any} precedence ip-precedence-list [[multicast] set-ip-dscp
value] command.
Parameters
ip
ipv6
ip-any
ip-
precedence-list
set-ip-dscp
value
Defaults none
Command CLASS-MAP CONFIGURATION (config-class-map)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.5(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.19.0
8.3.11.1
Quality of Service (QoS)
Enter the keyword ip to support IPv4 traffic.
Enter the keyword ipv6 to support IPv6 traffic.
Enter the keyword ip-any to support IPv4 and IPv6 traffic.
Enter the IP precedence value(s) as the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 7.
(OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Description
Added support for the ipv6 and ip-any options on the
Z9500.
Added support for the ipv6 and ip-any options on the
Z9000, S6000, S4820T, S4810, MXL.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4820T.
Introduced on the Z9000.
1451