Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual page 225

Copyright © 2010, Juniper Networks, Inc.
encapsulation—Available options differ for ATM interfaces and dynamic ATM 1483
subinterfaces, as follows:
For PVCs created on ATM interfaces:
aal5all—Causes the router to pass through all ATM AAL5 traffic without interpreting
it; supported for ATM layer 2 services over MPLS
aal0—Causes the router to receive raw ATM cells on this circuit and forward the
cells without performing AAL5 packet reassembly; supported for ATM layer 2
services over MPLS
aal5snap—LLC encapsulated circuit; LLC/SNAP header precedes the protocol
datagram
aal5mux ip—VC-based multiplexed circuit used for IP only
aal5autoconfig—Enables autodetection of the 1483 encapsulation (LLC/SNAP
or VC multiplexed)
ilmi—Integrated local management interface encapsulation
For PVCs created on dynamic ATM 1483 subinterfaces:
aal5snap—LLC encapsulated circuit; LLC/SNAP header precedes the protocol
datagram
aal5mux ip—VC-based multiplexed circuit used for IP only
aal5autoconfig—Enables autodetection of the 1483 encapsulation (LLC/SNAP
or VC multiplexed)
cbr—Constant bit rate in Kbps
peak—PCR in Kbps
average—Average rate in Kbps; also referred to as SCR
burst—Length in cells of the burst; also referred to as MBS
rt—Selects VBR-RT as the service type; the default type is VBR-NRT. You can select
rt only if you set the peak, average, and burst parameters.
oam—Enables generation of OAM F5 loopback cells on this circuit. This option enables
VC integrity features that affect the operational state of the ATM PVC. You can use
the oam keyword only if you specify the aal5snap, aal5autoconfig, or aal5mux ip
encapsulation type.
seconds—Time interval in the range 1–600 seconds between transmissions of OAM
F5 end-to-end loopback cells for VC connectivity verification.
inArp—Enables Inverse ARP. You can use the inArp keyword only if you specify the
aal5snap encapsulation type.
minutes—Inverse ARP refresh rate in minutes; 15 minutes is the default
cc—Enables CC cells on the PVC; you can enable CC cells only on data circuits, not on
control circuits, such as ILMI or signaling circuits
Chapter 2: A Commands
181