Managing Switch Fabric Modules; Display Switch Fabric Module Status; Swm: Switch Modules (1) Dss: Display Switch Status - 3Com CoreBuilder 9000 User Manual

Managing Switch
Fabric Modules
Display Switch Fabric
Module Status
Slot id Slot status
------- ------------
* * 8 Occupied
9
S Switch MAC address: 00.c0.da.7f.92.29
w Switch sys up time: 0 day(s), 00:38:11
You can display Switch Fabric Module information for the
CoreBuilder 9000 ATM Enterprise Switch.

Display Switch Fabric Module Status

Reset Switch


Reset Standby Switch Fabric Module


Set Standby Switch Fabric Module to Suspended/ In-service Mode


Upgrade Software Files
Display information about each of the switch fabric modules present. If
there are two switch fabric modules, one is used for standby. See the
CoreBuilder 9000 Switch Fabric Module Getting Started Guide for more
information about standby Switch Fabric Modules.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 4 1
ATM Switch Fabric Module information is displayed:
Switch type
----------------
22x22 ATM switch
Occupied 22x22 ATM switch

Managing Switch Fabric Modules

(4) SWM: Switch modules
(1) DSS: Display Switch status
1 4 1
CoreBuilder 9000 ATM Switch Fabric Module
information is displayed.
Information is displayed as shown in the example.
Switch mode
------------
Active
In-Srv STBY
95
Memory size
------------
64 MB
64 MB