Mitel SX-200 Practices page 1055

m .
Attendant Console
Chart 2-l Install LCD Attendant Console
Step
1.
.-
2.
\
3.
4.
5.
6.
7.
6.
9.
e
10.
II.
12.
Action
nventoty, Unpack, Inspect
Check off received items against packing list and
equipment list, above.
Jnpack cartons.
rag defective items.
4 in relevant portion of damage report.
qepack tagged items and return according to
ocal procedures,
assemble Console
Connect the headset (or handset) to its cord.
4ug the cord into the jack at the side of the
console.
~osltlon Console
%t the console in its assigned position.
'lug one end of the console modular cord into
:he jack at the back of the console, and the other
snd into its assigned modular telephone jack.
Connect Console
Connect the modular telephone jack to the
xoss-connect field.
Connect the console module on the universal
card to the cross-connect field.
At the distribution frame, cross connect the cable
horn the modular jack to the console module on
the universal card.
Comments
Packaging shown in Figure 2-4..
The two jacks are connected in
parallel: either can be used.
Maximum loop length is 305m
(1000 ft).
CAUTION: No bridge taps are
permitted.
Figure 2-3 shows console
positioning and maximum cable
lengths.
The console jack is marked LINE
PORT.
Note: Only MITEL cable
559900030 or 9109-007-9O&NA
can be used for the modular cord.
The yellow and black leads (line
out) connect through the
cross-connect field to a console
module Tip/Ring pair 1.
The green/red leads (line in)
connect through the cross-connect
filed to a console module Tip/Ring
pair 2.
Section 5 gives cross-connect
cabling information.
9109-096-126-NA Issue 1
Revision 0
126 2-5