Testprocedures - Mitel SX-200 Practices

m .
SUPERSfl4
Description
Call Announce Port Installation on a
SUPERSET
4 Telephone
Refer to Practice 9109-096-I 05NA, Features Description,for programming
information. Connect the Tip and Ring of the announce port circuit to the YELLOW (Tip)
and BLACK (Ring) leads of the associated
SUPERSET
4 telephone modular jack.
Note: The Call Announce Port of the SUPERSET4Telephone connects to either an OPS Card,
a COVcard, or an analog Line Card, but NOT to a SUPERSW
Line Card or an ONS card.
Refer to Figure 5-5.
;
Card or COV Card
Cross-Connect Field
SlJPERSET4 Telephone
Figure 5-5 Call Announce Port Connections
Test Procedures
5.7 Perform these
SUPERSET
4 test procedures as operational tests after initial
installation of a system.
Whenever a
SUPERSET
4 telephone is connected to an operating system, or the
system has just been powered up, this test is run automatically. A message in the
following format appears on the
SUPERSET
telephone LCD: ":SS4 V)CUX.XX:", for
approximately 30 seconds. Time and date are then displayed. If the test fails, verily that
the system is installed correctly and is powered up. Refer to the appropriate MITEL
practices for system installation instructions.
Satisfactory completion of the test procedures listed in Table 5-2 confirms correct key
operation, liquid crystal display activation, hookswitch functioning, and speaker output,
and checks that the set has been installed correctly.
Perform the tests listed in Table 5-2 at each
SUPE/?SET4
telephone. If any test fails,
verify that the system is installed correctly and is powered up.
9109-996-l 26-NA
Issue 1
Revision 0
126 5-11