Digital Line Card; General Description; Facilities - Mitel SX-200 Practices

13
n
DIGITAL LINE CARD
Any connection of this card to an off premise applicaUon, an out of plant appli-
cation, or to any other exposed plant applicaUon may result in a safety hazard,
and/or defective operation, and/or equipment damage.
.
General Description
13.1 The Digital Line Card (DLC), part number 9109-012~XXX, interfaces DATASETs,
the SUPERCONSOLE 1000W Attendant Console, SUPERSET DS9 Module,
SUPERSET3mDN and SUPERSET4mDN, SUPERSET407m,
SUPERSET 41 Om, SUPERSET 420W, and SUPERSET 43p telephones to the
SX-200 DIGITAL PABX. It contains 12 asynchronous line circuits &llTEL@ Digital
Network lntetface Circuit), and is a low power digital card which can plug into any slot
within a digital bay.
Note: If a SUPERCONSOLE IOOOAttendant Console is connected to the DLC, the DLC must
be installed in an upper slot,
Note: The SUPERSET 401, SUPERSET 410, SUPERSET 420, and SUPERSET 430
telephones can only be used with Generic 1005. The SUPERSET telephone is not
available with Generic 1005 FPKGl .
The card is 158 mm high x 368 mm long (6.2 in. x 14.5 in.).
There are 13 LEDs on the face of the card. The top 12, one for each line circuit, light
when the circuit is in use. The bottom LED on the panel lights to indicate an alarm
condition within the card.
Facilities
13.2 Each Digital Network lntetface Circuit (DNIC) provides the following facilities:
0 line protection
l
full duplex simultaneous data and voice digital transmission over a single pair of
wire
l
line circuit status monitoring
l
signaling and HDLC protocol to its associated DATASET,
9109-096-125-NA Issue 1 Revision 0
125 13-l