Table of Contents
Advertisement
1
System Overview
Installation "Preflight" Checkout
The 8510XF network analyzer system has been designed to measure
broadband devices to 110 GHz, on-wafer or coax, fully calibrated, in a
single frequency sweep.
Single RF connection to 110 GHz
The 8510XF system provides frequency coverage from 45 MHz to 110 GHz
in a single sweep with a single connection.
Millimeter-wave measurements in 1.0 mm coax
With a single connection, fully error-corrected measurements to 110 GHz
are made in 1.0 mm coax. Making millimeter-wave measurements in
1.0 mm coax delivers uncompromised performance and improved
productivity compared to waveguide.
Convenient millimeter-wave on-wafer measurements
The 8510XF system is designed for convenient on-wafer measurements
using the 1.0 mm coax connector to interface with the 1.0 mm wafer probe.
Broadband calibration with built-in firmware
The built-in firmware of the 8510XF system enables you to perform a single
calibration from 45 MHz to 110 GHz, either in coax or on-wafer.
8510XF Service Quick Reference Guide 1-1
Advertisement
Chapters
Table of Contents
