Dlp-H98 Enable Pointer Justification Count Performance Monitoring - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99

DLP-H98 Enable Pointer Justification Count Performance Monitoring

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the 15310E-CTX-K9 card. The card view appears.
Step 1
Click the Provisioning > Optical > Line tabs.
Step 2
Click the PJStsMon# menu and make a selection based on the following rules:
Step 3
•
•
Step 4 In the Service State field, confirm that the port is in the In-Service and Normal (unlocked-enabled)
service state.
If the port is unlocked-enabled, click Apply and go to
Step 5
If the port is in the Out-of-Service and Disabled (OOS,DSLBD); Out-of-Service and Maintenance
Step 6
(locked, maintenance); or In-Service and Automatic In-Service (Automatic In Service), select unlocked
in the Admin State field and click Apply.
Click the Performance tab to view PM parameters. Refer to the Cisco ONS 15310-MA SDH Reference
Step 7
Manual for more PM information, details, and definitions.
Note
Return to your originating procedure (NTP).
Step 8
78-19416-01
The default value Off means pointer justification monitoring is disabled.
The values 1 to N are the number of VC high-order paths on the port. One VC high-order path per
port can be enabled from the PJStsMon# card drop-down list.
In CTC, the count fields for PPJC and NPJC PM parameters appear white and blank unless they
are enabled on the Provisioning > Optical > Line tabs.
This task enables pointer justification counts, which provide a way to
align the phase variations in VC high-order path and VC low-order path
payloads and to monitor the clock synchronization between nodes. A
consistent, large pointer justification count indicates clock
synchronization problems between nodes.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Step
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
7.
16-115