Lldp Med; Lldp Med Fast-Start-Repeat-Count - Cisco 220 Series Smart Plus Reference Manual

LLDP Commands

lldp med

lldp med

lldp med fast-start-repeat-count

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To enable LLDP Media Endpoint Discovery (MED) on an interface, use the lldp med
Interface Configuration mode command.
To disable LLDP MED on an interface, use the no form of this command.
Syntax
lldp med {enable | disable}
no lldp med
Parameters
• enable—Enables LLDP MED on the interface.
• disable—Disables LLDP MED on the interface.
Default Configuration
LLDP MED is enabled with the network-policy TLV.
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface gi3
switchxxxxxx(config-if)# lldp med enable
When an interface comes up, LLDP can send packets more quickly than usual
using its fast start mechanism. To configure the number of packets that is sent
during the activation of the fast start mechanism, use the lldp med fast-start-
repeat-count Global Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
lldp med fast-start-repeat-count
number
22
320