Show Ip Access-Lists - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

show ip access-lists

Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and

the count of matches/mismatches against each ACL entry displayed.

show ip access-lists [access-list-name] [interface interface]

[in | out] [vrf vrf-name]

access-list-

EXEC Privilege

Enter the name of a configured MAC ACL, up to 140

Enter the keyword interface followed by the one of the

following keywords and slot/port or number information:

For a VLAN interface, enter the keyword vlan followed

by the slot/port number.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port

information.

For a Port Channel interface, enter the keyword port-

channel followed by a number. For Z9500, the range is

from 1 to 512. For the E-Series, the range is 1 to 255 for

TeraScale and 1 to 512 for ExaScale.

For a SONET interface, enter the keyword sonet

followed by the slot/ port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by the slot/port information.

Identify whether ACL is applied on the ingress or egress side.

Added support for the 4-port 40G line cards on ExaScale.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Access Control Lists (ACL)