Show Ip Tcp Initial-Time - Dell S6000 Reference Manual

Usage A warning message is displayed when you enter this command stating that this
Information setting takes effect for existing routes only when IPv4 route prefixes are cleared
from the routing table (RTM). To disable this functionality, use no ipv4 unicast-
host-route command.
Example
Dell(conf)#ip unicast-host-route
Warning: Command will take effect for existing routes only
when IPv4
route prefixes are cleared from RTM
Dell(conf)#no ip unicast-host-route

show ip tcp initial-time

Displays the interval that you configured for the device to wait before the TCP connection is attempted to
be established. This command is supported on the , , S6000, , and MXL platforms.
Syntax
show ip tcp initial-time
Command
EXEC
Modes
EXEC Privilege
Command
Version 9.3(0.0)
History
ip unreachables
Enable the generation of internet control message protocol (ICMP) unreachable messages.
S6000
Syntax
ip unreachables
To disable the generation of ICMP messages, use the no ip unreachables
command.
Defaults Disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
738
Introduced on the S4810, S4820T, S6000, Z9000, and MXL
platforms.
IPv4 Routing