Ip Control-Plane Egress-Filter; Show Ip Accounting Access-List - Dell S4810 Reference Manual

Use the vrf attribute of this command to associate an access-list to a non-default
VRF. You can use this command at the interface context (physical/LAG) to apply
the access-list to a range of VRFs.
The VRF MODE is not available for the default and management VRFs.
Related
ip access-list standard
Commands
ip access-list extended

ip control-plane egress-filter

Enable egress Layer 3 ACL lookup for IPv4 CPU traffic.
S4810
Syntax
ip control-plane egress-filter
Defaults Not enabled.
Command EXEC Privilege
Modes
Command
Version 9.0.2.0
History
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0

show ip accounting access-list

Display the IP access-lists created on the switch and the sequence of filters.
S4810
Syntax
show ip accounting {access-list access-list-name | cam_count}
interface interface [vrf vrf-name]
Parameters
access-list-
name
cam_count
interface
interface
Access Control Lists (ACL)
— configures a standard ACL.
— configures an extended ACL.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Enter the name of the ACL to be displayed.
List the count of the CAM rules for this ACL.
Enter the keyword interface then the one of the following
keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword port-
channel then a number. For the C-Series and S-Series,
the range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
211