Configuration Task List For Ospfv3 (Ospf For Ipv6); Enabling Ipv6 Unicast Routing - Dell Z9500 Configuration Manual

Z-series core and aggregation switche

Hide thumbs Also See for Z9500:

Table of Contents

OSPF Area 0 — Te 1/1 and 1/2

OSPF Area 0 — Te 3/1 and 3/2

OSPF Area 0 — Te 2/1 and 2/2

Configuration Task List for OSPFv3 (OSPF for IPv6)

This section describes the configuration tasks for Open Shortest Path First version 3 (OSPF for IPv6) on the switch.

The configuration options of OSPFv3 are the same as those options for OSPFv2, but you may configure OSPFv3 with differently

labeled commands. Specify process IDs and areas and include interfaces and addresses in the process. Define areas as stub or

totally stubby.

The interfaces must be in IPv6 Layer-3 mode (assigned an IPv6 IP address) and enabled so that they can send and receive

traffic. The OSPF process must know about these interfaces. To make the OSPF process aware of these interfaces, assign them

to OSPF areas.

The OSPFv3 ipv6 ospf area command enables OSPFv3 on the interface and places the interface in an area. With OSPFv2,

two commands are required to accomplish the same tasks — the router ospf command to create the OSPF process, then

the network area command to enable OSPF on an interface.

The OSPFv2 network area command enables OSPF on multiple interfaces with the single command. Use the

OSPFv3 ipv6 ospf area command on each interface that runs OSPFv3.

All IPv6 addresses on an interface are included in the OSPFv3 process that is created on the interface.

Enable OSPFv3 for IPv6 by specifying an OSPF process ID and an area in INTERFACE mode. If you have not created an OSPFv3

process, it is created automatically. All IPv6 addresses configured on the interface are included in the specified OSPF process.

IPv6 and OSPFv3 do not support Multi-Process OSPF. You can only enable a single OSPFv3 process.

Set the time interval between when the switch receives a topology change and starts a shortest path first (SPF) calculation.

timers spf delay holdtime

Dell(conf)#ipv6 router ospf 1

Dell(conf-ipv6-router_ospf)#timer spf 2 5

Dell(conf-ipv6-router_ospf)#

Dell(conf-ipv6-router_ospf)#show config

ipv6 router ospf 1

timers spf 2 5

Dell(conf-ipv6-router_ospf)#

Dell(conf-ipv6-router_ospf)#end

To enable IPv6 unicast routing, use the following command.

Enable IPv6 unicast routing globally.

CONFIGURATION mode

Open Shortest Path First (OSPFv2 and OSPFv3)