Examples
# Output system information to the monitor through channel 0.
<Sysname> system-view
[Sysname] info-center monitor channel 0
info-center snmp channel
Use info-center snmp channel to configure the SNMP output channel. The system uses this channel to
output information to the SNMP module.
Use undo info-center snmp channel to restore the default SNMP output channel.
Syntax
info-center snmp channel { channel-number | channel-name }
undo info-center snmp channel
Default
The system outputs information to the SNMP module through channel 5 (snmpagent).
Views
System view
Default command level
2: System level
Parameters
channel-number: Specifies a channel by its number in the range of 0 to 9.
channel-name: Specifies a channel by its name, a default name or a self-defined name. For information
about configuring a channel name, see the info-center channel name command.
Examples
# Output system information to the SNMP module through channel 6.
<Sysname> system-view
[Sysname] info-center snmp channel 6
Related commands
display snmp-agent
info-center source
Use info-center source to configure an information output rule for a module.
Use undo info-center source to remove the specified output rule.
Syntax
info-center source { module-name | default } channel { channel-number | channel-name } [ debug { level
severity | state state } * | log { level severity | state state } * | trap { level severity | state state } * ] *
undo info-center source { module-name | default } channel { channel-number | channel-name }
Default
The default output rules are listed in
Table
50.
221