Info-Center Snmp Channel - H3C S5120-SI Series Command Reference Manual

By default, output of system information to the monitor is enabled with a default channel name of
monitor and a default channel number of 1.
Note that the info-center monitor channel command takes effect only after the information center is
enabled with the info-center enable command.
Examples
# Output system information to the monitor through channel 0.
<Sysname> system-view
[Sysname] info-center monitor channel 0

info-center snmp channel

Syntax
info-center snmp channel { channel-number | channel-name }
undo info-center snmp channel
View
System view
Default Level
2: System level
Parameters
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a self-defined name. The
user needs to specify a channel name first before using it as a self-defined channel name. For more
information, refer to the info-center channel name command.
Description
Use the info-center snmp channel command to configure the channel to output system information to
the SNMP module.
Use the undo info-center snmp channel command to restore the default channel to output system
information to the SNMP module.
By default, output of system information to the SNMP module is enabled with a default channel name of
snmpagent and a default channel number of 5.
For more information, refer to the display snmp-agent command in the SNMP Commands.
Examples
# Output system information to the SNMP module through channel 6.
<Sysname> system-view
[Sysname] info-center snmp channel 6
1-19