LC (Line Configuration) Mode
Command
enable authentication
exec-banner
exec-timeout
history
history size
login-banner
motd-banner
password
autobaud
speed
MA (Management Access-level) Mode
Command
deny (management)
permit (management)
PE (Privileged User EXEC) Mode
Command
boot system
clear arp-cache
clear bridge
clear gvrp statistics
clear host
clear host dhcp
clear ipv6 neighbors
clear logging
70
Command Modes
Description
Specifies the authentication method list when accessing a higher privilege level
from a remote telnet or console.
Enables the display of exec banners.
Configures the interval that the system waits until user input is detected.
Enables the command history function.
Changes the command history buffer size for a particular line.
Enables the display of login banners.
Enables the display of message-of-the-day banners.
Specifies a password on a line.
Sets the line for automatic baud rate detection
Sets the line baud rate.
Description
Defines a deny rule.
Defines a permit rule.
Description
Specifies the system image that the device loads at startup.
Deletes all dynamic entries from the ARP cache.
Removes any learned entries from the forwarding database.
Clears all the GVRP statistics information.
Deletes entries from the host name-to-address cache
Deletes entries from the host name-to-address mapping received from Dynamic
Host Configuration Protocol (DHCP).
Deletes all entries in the IPv6 neighbor discovery cache, except static entries.
Clears messages from the internal logging buffer.