E-Series
Usage
Users entering EXEC Privilege mode or any other configured privilege level can access
Information
configuration commands. To protect against unauthorized access, use the enable
password command to configure a password for the enable command at a specific
privilege level. If no privilege level is specified, the default is privilege level 15.
Related
enable password
Commands
privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Z-Series, S4810
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-
update interval command.
Parameters
interval
Defaults
Disabled
Command Modes
CONFIGURATION
Command History
Version 8.3.11.4
Version 8.3.10.0
Usage
Use this command to enable polling and to configure the polling frequency.
Information
enable xfp-power-updates
Enable 10–gigabit small form-factor pluggable (XFP) power updates for SNMP.
C-Series, E-Series, S-Series
Syntax
enable xfp-power-updates interval seconds
Original command.
– configures a password for the enable command and to access a
seconds
Enter the keyword interval followed by the polling interval in
seconds. Range: 120 to 6000 seconds. Default: 300 seconds (5
minutes).
Introduced on the Z9000 to replace the enable xfp-power-
updates command.
Replacement command for the S4810 only. Replaces the enable
xfp-power-updates command.
115