[26-129] Ipv6-Ndra-Prefix; [26-141] Downstream-Calculated-Qos-Rate - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual
Software for e series broadband services routers broadband access configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
- Configuration manual (750 pages)
Table of Contents
Advertisement
radius include ipv6-nd-ra-prefix
radius include downstream-calculated-qos-rate
Copyright © 2010, Juniper Networks, Inc.
Example
host1(config)#radius include l2c-downstream-data access-request enable
Use the no version to restore the default, disable.
See radius include
[26-129] Ipv6-NdRa-Prefix
Use the following command to manage the Ipv6-NdRa-Prefix RADIUS attribute.
radius include ipv6-nd-ra-prefix
Use to include the IPv6-NdRa-Prefix attribute in Acct-Start, or Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
The value of this attribute received from the RADIUS server in the Access-Accept
message is included in the accounting messages.
For dynamic interfaces, if the Ipv6-NdRa-Prefix attribute is configured in the profile
and is not returned from RADIUS server, this attribute is not included in the Acct-Start,
Acct-Stop, and Interim-Acct messages.
See radius include
Example
host1(config)#radius include ipv6-nd-ra-prefix acct-start enable
Use the no version to restore the default, disable.
[26-141] Downstream-Calculated-Qos-Rate
The Downstream-Calculated-Qos-Rate RADIUS attribute enables RADIUS to receive
calculated QoS rates from ANCP.
Use the following command to manage the Downstream-Calculated-Qos-Rate RADIUS
attribute.
radius include downstream-calculated-qos-rate access-request
radius include downstream calculated-qos-rate acct-start
radius include downstream-calculated-qos-rate acct-stop
Use to include the Downstream-Calculated-Qos-Rate attribute in Access-Request,
Acct-Start, and Acct-Stop messages.
You can control inclusion of the Downstream-Calculated-Qos-Rate attribute by
enabling or disabling this command. Inclusion is disabled by default.
Example
host1(config)#radius include downstream-calculated-qos-rate access-request enable
Chapter 3: Configuring RADIUS Attributes
227
Advertisement
Table of Contents
Troubleshooting
