L2C-Down-Stream-Data; Ipv6-Ndra-Prefix - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

[26-93] L2C-Down-Stream-Data

Use the following command to manage the L2C-Down-Stream-Data RADIUS attribute.
radius include l2c-downstream-data

[26-129] Ipv6-NdRa-Prefix

Use the following command to manage the Ipv6-NdRa-Prefix RADIUS attribute.
radius include ipv6-nd-ra-prefix
Example
host1(config)#radius include l2c-upstream-data access-request enable
Use the no version to restore the default, disable.
radius include l2c-downstream-data
Use to include the L2C-Down-Stream-Data attribute in Access-Request, Acct-Start,
and Acct-Stop messages.
You can control inclusion of the L2C-Down-Stream-Data attribute by enabling
or disabling this command. Inclusion is disabled by default.
Example
host1(config)#radius include l2c-downstream-data access-request enable
Use the no version to restore the default, disable.
See radius include
radius include ipv6-nd-ra-prefix
Use to include the IPv6-NdRa-Prefix attribute in Acct-Start, or Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
The value of this attribute received from the RADIUS server in the Access-Accept
message is included in the accounting messages.
For dynamic interfaces, if the Ipv6-NdRa-Prefix attribute is configured in the
profile and is not returned from RADIUS server, this attribute is not included in
the Acct-Start, Acct-Stop, and Interim-Acct messages.
See radius include
Example
host1(config)#radius include ipv6-nd-ra-prefix acct-start enable
Use the no version to restore the default, disable.
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
225