Digital-To-Analog Converter (Dac); Dac Introduction; Dac Main Features - ST STM32F40 Series Reference Manual

RM0090
12

Digital-to-analog converter (DAC)

This section applies to the whole STM32F4xx family devices, unless otherwise specified.
12.1

DAC introduction

The DAC module is a 12-bit, voltage output digital-to-analog converter. The DAC can be
configured in 8- or 12-bit mode and may be used in conjunction with the DMA controller. In
12-bit mode, the data could be left- or right-aligned. The DAC has two output channels, each
with its own converter. In dual DAC channel mode, conversions could be done
independently or simultaneously when both channels are grouped together for synchronous
update operations. An input reference pin, V
resolution.
12.2

DAC main features

● Two DAC converters: one output channel each
●
Left or right data alignment in 12-bit mode
● Synchronized update capability
●
Noise-wave generation
● Triangular-wave generation
●
Dual DAC channel for independent or simultaneous conversions
●
DMA capability for each channel
●
DMA underrun error detection
●
External triggers for conversion
●
Input voltage reference,
Figure 54
V
REF+
shows the block diagram of a DAC channel and
Doc ID 018909 Rev 4
Digital-to-analog converter (DAC)
(shared with ADC) is available for better
REF+
Table 57 gives the pin description.
310/1422