Simultaneous Trigger With Single Lfsr Generation; Simultaneous Trigger With Different Lfsr Generation; Simultaneous Trigger With Single Triangle Generation - ST STM32F40 Series Reference Manual

RM0090
12.4.8

Simultaneous trigger with single LFSR generation

To configure the DAC in this conversion mode, the following sequence is required:
●
Set the two DAC channel trigger enable bits TEN1 and TEN2
●
Configure the same trigger source for both DAC channels by setting the same value in
the TSEL1[2:0] and TSEL2[2:0] bits
●
Configure the two DAC channel WAVEx[1:0] bits as "01" and the same LFSR mask
value in the MAMPx[3:0] bits
●
Load the dual DAC channel data to the desired DHR register (DHR12RD, DHR12LD or
DHR8RD)
When a trigger arrives, the LFSR1 counter, with the same mask, is added to the DHR1
register and the sum is transferred into DAC_DOR1 (three APB1 clock cycles later). The
LFSR1 counter is then updated. At the same time, the LFSR2 counter, with the same mask,
is added to the DHR2 register and the sum is transferred into DAC_DOR2 (three APB1 clock
cycles later). The LFSR2 counter is then updated.
12.4.9

Simultaneous trigger with different LFSR generation

To configure the DAC in this conversion mode, the following sequence is required:
●
Set the two DAC channel trigger enable bits TEN1 and TEN2
● Configure the same trigger source for both DAC channels by setting the same value in
the TSEL1[2:0] and TSEL2[2:0] bits
●
Configure the two DAC channel WAVEx[1:0] bits as "01" and set different LFSR mask
values using the MAMP1[3:0] and MAMP2[3:0] bits
●
Load the dual DAC channel data into the desired DHR register (DAC_DHR12RD,
DAC_DHR12LD or DAC_DHR8RD)
When a trigger arrives, the LFSR1 counter, with the mask configured by MAMP1[3:0], is
added to the DHR1 register and the sum is transferred into DAC_DOR1 (three APB1 clock
cycles later). The LFSR1 counter is then updated.
At the same time, the LFSR2 counter, with the mask configured by MAMP2[3:0], is added to
the DHR2 register and the sum is transferred into DAC_DOR2 (three APB1 clock cycles
later). The LFSR2 counter is then updated.
12.4.10

Simultaneous trigger with single triangle generation

To configure the DAC in this conversion mode, the following sequence is required:
●
Set the two DAC channel trigger enable bits TEN1 and TEN2
●
Configure the same trigger source for both DAC channels by setting the same value in
the TSEL1[2:0] and TSEL2[2:0] bits
●
Configure the two DAC channel WAVEx[1:0] bits as "1x" and the same maximum
amplitude value using the MAMPx[3:0] bits
●
Load the dual DAC channel data into the desired DHR register (DAC_DHR12RD,
DAC_DHR12LD or DAC_DHR8RD)
When a trigger arrives, the DAC channel1 triangle counter, with the same triangle amplitude,
is added to the DHR1 register and the sum is transferred into DAC_DOR1 (three APB1 clock
cycles later). The DAC channel1 triangle counter is then updated.
At the same time, the DAC channel2 triangle counter, with the same triangle amplitude, is
Doc ID 018909 Rev 4
Digital-to-analog converter (DAC)
320/1422