Suzuki Baleno Manual page 1362

6-2-14 ENGINE GENERAL INFORMATION AND DIAGNOSIS (J18 ENGINE WITH WU TWC)
DIAGNOSTIC TROUBLE CODE (DTC)
CLEARANCE
1) Connect generic scan tool or SUZUKI scan tool to data link con-
nector in the same manner as when making this connection for
DTC check.
2) Turn ignition switch OFF and then ON.
3) Erase DTC and pending DTC according to instructions dis-
played on scan tool. Refer to scan tool operator's manual for fur-
ther details.
4) After completing the clearance, turn ignition switch off and dis-
connect scan tool from data link connector.
NOTE:
DTC and freeze frame data stored in ECM memory are also
cleared in the following cases. Be careful not to clear them
before keeping their record.
D When power to ECM is cut off (by disconnecting battery
cable, removing fuse or disconnecting ECM connectors
for 30 sec. or longer).
D When the same malfunction (DTC) is not detected again
during 40 engine warm-up cycles.