Hydraulic Device/Hecu Assembly - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

REMOVAL AND INSTALLATION

HYDRAULIC DEVICE/HECU ASSEMBLY

ABS
REXTON SM - 2004.4
Removal and Installation
1. Disconnect the negative cable.
2. Disconnect the ABS wiring harness connector from HECU
socket.
3. Cover the connector and the socket with shop cloths to
protect them from brake fluid.
Y220_8E1028
Notice
Take care not to allow air into the hydraulic
modulator. If air gets into the hydraulic unit, it will
require a bleeding procedure using a scan tool
programmed for the ABS 5.3 system. As long as no
air enters the hydraulic unit, a simple bleeding
procedure is all the system will require.
4. Remove the brake pipes from the hydraulic modulator.
Installation Notice
Tightening torque
Y220_8E1029
5. Loosen the mounting nuts on the hydraulic unit.
6. Move the brake pipes aside far enough to allow for lifting
the ABS 5.3 unit out of the mounting bracket.
7. Cap the brake pipes.
Installation Notice
Tightening torque
Bleed the air from the hydraulic system.
8. Install in the reverse order of removal.
Y220_8E1030
8E1-19
14 Nm
6 Nm
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN