SSANGYONG Rexton Y200 Manual page 1587

SSANGYONG Y200
Check
Check speed of front wiper motor
1. Remove connector from the motor of wiper.
2. Connect positive terminal into 3 terminal and
negative terminal into 6 terminal.
3. Check motor with low speed.
4. Connect positive terminal into 3 terminal and
negative terminal into 5 terminal.
5. Check motor with high speed.
YAD9D0P0
Check operation of automatic stop of front
1. Operate motor with low speed
2. After separating 6 terminal, stop operation of motor
except position of "OFF"
3. Connect 2 terminal and 6 terminal.
4. After connecting positive terminal into 3 terminal,
and then 4 terminal turn to the ground.
5. Check motor at the "OFF" position.
YAD9D0Q0
Check motor of rear wiper
1. Remove connector from the motor of rear wiper
2. Connect positive terminal into 4 terminal and
negative terminal into 3 terminal.
3. Check motor is operating normally, if motor has a
problem, replace motor.
Check washer motor
1. After installing washer motor into washer tank, and
then fill fluid of washer
2. Connect 1 terminal into positive terminal of battery
and 2 terminal into 3 negative terminal
3. Aftter motor of washer is operated, check the fluid
of washer is operated.
YAD9D0R0
BODY ELECTRICAL 9D-59